Last Modified: 01-30-2024 |
6.11:8.1.0 |
Doc ID: RM100000001E6NI |
Model Year Start: 2019 |
Model: RAV4 |
Prod Date Range: [11/2018 -
] |
Title: UB80F (AUTOMATIC TRANSMISSION / TRANSAXLE): DIFFERENTIAL OIL SEAL (for RH Side): REPLACEMENT; 2019 - 2024 MY RAV4 [11/2018 - ] |
REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during differential side oil seal and front drive shaft oil seal RH removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
for GF2A:
-
Front electro magnetic control clutch sub-assembly (transfer assembly)
|
Disconnect system function check
|
Dynamic torque vectoring AWD system
|
|
Front wheel alignment adjustment
|
-
Perform reset memory
-
Perform acceleration sensor zero point calibration and store system information memorization.
|
-
VSC is disabled or malfunctions
-
DTCs are output
-
Slip indicator light illuminates
-
ABS warning light illuminates
|
|
PROCEDURE
1. REMOVE TRANSFER ASSEMBLY
2. REMOVE DRIVE SHAFT BEARING BRACKET
Click here
3. REMOVE DIFFERENTIAL SIDE OIL SEAL
(a) Using a screwdriver with its tip wrapped with protective tape, remove the differential side oil seal from the transaxle housing.
NOTICE:
Be careful not to damage the front differential case or transaxle housing.
|
|
4. REMOVE FRONT DRIVE SHAFT OIL SEAL RH
(a) Using SST, remove the front drive shaft oil seal RH from the front differential case.
SST: 09308-00010
NOTICE:
Be careful not to damage the front differential case.
|
|
5. INSTALL FRONT DRIVE SHAFT OIL SEAL RH
(a) Coat the lip of a new front drive shaft oil seal RH with MP grease.
|
|
(b) Using SST and a hammer, install the front drive shaft oil seal RH to the front differential case.
SST: 09950-60011
09951-00410
SST: 09950-70010
09951-07200
Standard Depth:
21.5 to 22.5 mm (0.846 to 0.886 in.)
NOTICE:
-
Make sure to install the front drive shaft oil seal RH as specified, otherwise malfunctions such as a fluid leak will occur.
-
Do not damage the lip of the front drive shaft oil seal RH.
-
Do not remove the grease from the lip of the front drive shaft oil seal RH.
6. INSTALL DIFFERENTIAL SIDE OIL SEAL
(a) Coat the lip of a new differential side oil seal with MP grease.
(b) Using SST and a hammer, install the differential side oil seal to the transaxle housing.
SST: 09649-17010
SST: 09950-70010
09951-07200
Standard Depth:
5.5 to 6.5 mm (0.217 to 0.256 in.)
NOTICE:
-
Make sure to install the differential side oil seal as specified, otherwise malfunctions such as a fluid leak will occur.
-
Do not damage the lip of the differential side oil seal.
-
Do not install the differential side oil seal at an angle.
-
Do not remove the grease from the lip of the differential side oil seal.
|
|
7. INSTALL DRIVE SHAFT BEARING BRACKET
Click here
8. INSTALL TRANSFER ASSEMBLY
-
for GF1A:
Click here
-
for GF2A:
Click here
|