- Parking assist monitor system initialization
- Rear television camera assembly optical axis (Back camera position setting)
| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001E7N1 |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - ] |
| Title: PARK ASSIST / MONITORING: TELEVISION CAMERA (for Rear): REMOVAL; 2019 - 2024 MY RAV4 RAV4 HV [11/2018 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during television camera assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
|
Replaced Part or Performed Procedures |
Necessary Procedures |
Effect/Inoperative Function when Necessary Procedures are not Performed |
Link |
|---|---|---|---|
|
Television camera assembly (Including removal and installation) |
|
Parking assist monitor system |
|
|
Television camera view adjustment |
Panoramic view monitor system (for HV model) |
|
Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
|
Replaced Part or Performed Procedures |
Necessary Procedures |
Effect/Inoperative Function when Necessary Procedures are not Performed |
Link |
|---|---|---|---|
|
Television camera assembly (Including removal and installation) |
|
Parking assist monitor system |
|
|
Television camera view adjustment |
Panoramic view monitor system (for Gasoline model) |
|
PROCEDURE
1. REMOVE BACK DOOR CENTER GARNISH
Click here
![2019 - 2023 MY RAV4 RAV4 HV [11/2018 - 10/2023]; DOOR / HATCH: BACK DOOR: DISASSEMBLY+](/t3Portal/stylegraphics/info.gif)
2. REMOVE BACK DOOR SIDE GARNISH LH
Click here
3. REMOVE BACK DOOR SIDE GARNISH RH
HINT:
Use the same procedure described for the LH side.
4. REMOVE BACK DOOR GRIP BASE
Click here
5. REMOVE BACK DOOR GRIP
HINT:
Use the same procedure described for the back door grip base.
6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY
Click here
7. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Click here
8. REMOVE TELEVISION CAMERA ASSEMBLY
|
(a) Disconnect the connector. |
|
|
(b) Remove the 2 screws. |
|
(c) Using pliers, grip the claw of the 2 screw grommets and slide the 2 screw grommets to remove the television camera assembly and 2 screw grommets as shown in the illustration.
|
*1 |
Screw Grommet |
|
Remove in this Direction |
9. REMOVE SCREW GROMMET
|
|