INSTALLATION

PROCEDURE

1. INSTALL V-RIBBED BELT

HINT:

When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.

(a) Set the V-ribbed belt onto each pulley as shown in the illustration.

*1 Crankshaft Pulley Assembly *2 Generator Assembly *3 Compressor Assembly With Pulley

(b) Turn the V-ribbed belt tensioner assembly clockwise and remove the 5 mm hexagon wrench.

(c) After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.

*a Correct *b Incorrect

2. INSTALL FRONT FENDER APRON SEAL RH

Click here