REAR SUSPENSION: REAR COIL SPRING: INSTALLATION; 2019 MY RAV4 RAV4 HV [11/2018

Last Modified: 01-30-2024	6.11:8.1.0	Doc ID: RM100000001ECE8
Model Year Start: 2019	Model: RAV4	Prod Date Range: [11/2018 - 02/2019]
Title: REAR SUSPENSION: REAR COIL SPRING: INSTALLATION; 2019 MY RAV4 RAV4 HV [11/2018 - 02/2019]

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

1. INSTALL REAR UPPER COIL SPRING INSULATOR

(a) Install the rear upper coil spring insulator to the vehicle.

2. INSTALL REAR LOWER COIL SPRING INSULATOR

(a) Install the rear lower coil spring insulator to the rear No. 2 suspension arm assembly.

3. INSTALL REAR COIL SPRING

(a) for TMC Made:

(1) Set the rear coil spring to the rear No. 2 suspension arm assembly.

NOTICE:

Set the rear coil spring so that its lower end is within the range shown in the illustration.
Set the rear coil spring so that the identification mark is positioned as shown in the illustration.
The smaller diameter end must face upward.

*a	Identification Mark
*b	30° or less
*c	Lower End of Rear Coil Spring
	Inner Side of the Vehicle

(b) for TMMC Made:

(1) Set the rear coil spring to the rear No. 2 suspension arm assembly.

NOTICE:

Set the rear coil spring so that its lower end is within the range shown in the illustration.
Set the rear coil spring so that the identification mark is positioned as shown in the illustration.
The smaller diameter end must face upward.

*a	Identification Mark
*b	30° or less
*c	Lower End of Rear Coil Spring
	Inner Side of the Vehicle

(c) Using a jack and wooden block, slowly jack up the rear No. 2 suspension arm assembly and then install the rear No. 2 suspension arm assembly to the rear axle carrier sub-assembly with the bolt and nut.

CAUTION:

Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.

NOTICE:

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
Make sure to perform this operation with the vehicle kept as low as possible.
Insert the bolt with the threaded end facing the front of the vehicle.

4. STABILIZE SUSPENSION

Click here

5. INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY

(a) Install the rear No. 2 suspension arm assembly (rear axle carrier sub-assembly side) with the bolt.

Torque:

73 N·m {744 kgf·cm, 54 ft·lbf}

NOTICE:

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

6. INSTALL REAR STABILIZER LINK ASSEMBLY

Click here

7. INSTALL LOWER NO. 2 CONTROL ARM COVER (w/ Cover)

Click here

8. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Height Control Sensor)

(a) for LH Side:

Click here

9. INSTALL REAR WHEEL

Click here

10. INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY

(a) Install the rear No. 2 suspension arm assembly (rear suspension member sub-assembly side) with the nut.

Click here

11. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

Click here

12. PERFORM INITIALIZATION

Click here