- Side television camera assembly LH
- Outer rear view mirror assembly LH
- Side television camera assembly RH
- Outer rear view mirror assembly RH
| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001EF3M |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - ] |
| Title: MIRROR (EXT): OUTER REAR VIEW MIRROR: REMOVAL; 2019 - 2024 MY RAV4 RAV4 HV [11/2018 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
w/ Panoramic view monitor system:
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the outer rear view mirror assembly and side television camera assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
|
Replacement Part or Performed Procedure |
Necessary Procedures |
Effects/Inoperative Functions when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
|
Side television camera view adjustment |
Panoramic view monitor system (for HV model) |
|
Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
|
Replacement Part or Performed Procedure |
Necessary Procedures |
Effects/Inoperative Functions when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Side television camera view adjustment |
Panoramic view monitor system (for Gasoline model) |
|
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH
Click here
![2019 MY RAV4 RAV4 HV [11/2018 - 02/2019]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+](/t3Portal/stylegraphics/info.gif)
2. REMOVE FRONT DOOR ASSIST GRIP COVER LH
Click here
3. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
Click here
4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
Click here
5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
Click here
6. REMOVE OUTER MIRROR INSTALL HOLE COVER LH
|
(a) Disconnect the connector. |
|
(b) Detach the clamp.
|
(c) Remove the screw. |
|
(d) Detach the claw to remove the outer mirror install hole cover LH.
7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
(a) Remove the 3 nuts.
|
Protective Tape |
NOTICE:
Hold the outer rear view mirror assembly LH with one hand so that it does not drop.
(b) Using a thin-bladed screwdriver, detach the claw and guide to remove the outer rear view mirror assembly LH.
HINT:
Tape the thin-bladed screwdriver tip before use.
|
|