Last Modified: 01-30-2024 6.11:8.1.0 Doc ID: RM100000001EPGB
Model Year Start: 2019 Model: RAV4 Prod Date Range: [11/2018 -           ]
Title: LIGHTING (EXT): AUTOMATIC HIGH BEAM MAIN SWITCH: INSPECTION; 2019 - 2024 MY RAV4 RAV4 HV [11/2018 -        ]

INSPECTION

PROCEDURE

1. INSPECT AUTO HIGH BEAM SWITCH

(a) Inspect the automatic high beam main switch.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition
If the result is not as specified, replace the auto high beam switch.

5 (B) - 2 (E)

Automatic high beam main switch off

10 kΩ or higher

Automatic high beam main switch on

Below 1 Ω

*a

Component without harness connected

(Auto High Beam Switch)

(b) Check the illumination.

(1) Apply auxiliary battery voltage to the connector and check the illumination conditions.

OK:

Auxiliary Battery Connection

Specified Condition
If the result is not as specified, replace the auto high beam switch.

Auxiliary battery positive (+) → 6 (ILL+)

Auxiliary battery negative (-) → 1 (ILL-)

Illuminates

*a

Component without harness connected

(Auto High Beam Switch)

(c) Check the indicator.

(1) Apply auxiliary battery voltage to the connector and check the illumination conditions.

OK:

Auxiliary Battery Connection

Specified Condition
If the result is not as specified, replace the auto high beam switch.

Auxiliary battery positive (+) → 3 (IND+)

Auxiliary battery negative (-) → 4 (AZBI)

Illuminates

*a

Component without harness connected

(Auto High Beam Switch)