Last Modified: 01-30-2024 6.11:8.1.0 Doc ID: RM100000001EVBC
Model Year Start: 2019 Model: RAV4 HV Prod Date Range: [11/2018 -           ]
Title: A25A-FXS (ENGINE CONTROL): MASS AIR FLOW METER: INSPECTION; 2019 - 2024 MY RAV4 HV [11/2018 -        ]

INSPECTION

PROCEDURE

1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

(a) Perform a visual check for any foreign matter on the intake air temperature sensor (thermistor) of the mass air flow meter sub-assembly shown in the illustration.

OK:

There is no foreign matter.

If the result is not as specified, clean the intake air temperature sensor (thermistor).

*a

Intake Air Temperature Sensor (Thermistor)

(b) Clean the intake air temperature sensor (thermistor).

NOTICE:

  • Do not contact the mass air flow meter sub-assembly with the nozzle of the air blow gun.
  • Do not insert the nozzle of the air blow gun into the intake air temperature sensor (thermistor) area.

*a

Air Blow Gun

*b

10 mm (0.394 in.)

*c

Intake Air Temperature Sensor (Thermistor)

(1) Using an air blow gun, clean the intake air temperature sensor (thermistor) area of the mass air flow meter sub-assembly by applying approximately 10 intermittent bursts of air to the intake air temperature sensor (thermistor) area at a pressure of approximately 392 to 981 kPa (4.0 to 10.0 kgf/cm2, 57 to 142 psi).

HINT:

After performing cleaning, check the intake air temperature sensor (thermistor) resistance.

*a

Air Blow Duration

*b

3 to 6 Seconds

*c

1 Second

*d

Air Blowing

*e

Air Stopped

(c) Check the intake air temperature sensor (thermistor) resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

4 (THA) - 2 (E2G)

Always

0.47 to 19.3 kΩ

If the result is not as specified, replace the mass air flow meter sub-assembly.

*a

Component without harness connected

(Mass Air Flow Meter Sub-assembly)