Last Modified: 05-08-2025 6.11:8.1.0 Doc ID: RM100000001EVBL
Model Year Start: 2019 Model: RAV4 HV Prod Date Range: [11/2018 -           ]
Title: A25A-FXS (ENGINE CONTROL): CRANKSHAFT POSITION SENSOR: REMOVAL; 2019 - 2025 MY RAV4 HV [11/2018 -        ]

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here 2019 - 2025 MY RAV4 RAV4 HV [11/2018 -        ]; INTRODUCTION: REPAIR INSTRUCTION: PRECAUTION

PROCEDURE

1. REMOVE INLET AIR CLEANER ASSEMBLY

Click here 2019 MY RAV4 HV [11/2018 - 02/2019]; A25A-FXS (ENGINE CONTROL): THROTTLE BODY: REMOVAL+ 2019 - 2020 MY RAV4 HV [02/2019 - 08/2020]; A25A-FXS (ENGINE CONTROL): THROTTLE BODY: REMOVAL+ 2021 - 2025 MY RAV4 HV [08/2020 -        ]; A25A-FXS (ENGINE CONTROL): THROTTLE BODY: REMOVAL+

2. REMOVE CRANKSHAFT POSITION SENSOR

(a) Disconnect the crankshaft position sensor connector.

(b) Remove the bolt and crankshaft position sensor.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.

(c) Perform this procedure only when reusing the crankshaft position sensor.

(1) Remove the O-ring from the crankshaft position sensor.

NOTICE:

  • Make sure to only remove the O-ring with bare hands.
  • When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.
  • If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.

*1

O-ring