INSTALLATION

PROCEDURE

1. INSTALL NAVIGATION ECU

2. INSTALL NO. 2 MULTI-MEDIA MODULE BRACKET

(a) w/o Mayday System:

(1) Install the No. 2 multi-media module bracket with the 2 screws. Torque: 3.0 N·m {31 kgf·cm, 27 in·lbf}

(b) w/ Mayday System:

(1) Install the No. 2 multi-media module bracket with the 3 screws. Torque: 3.0 N·m {31 kgf·cm, 27 in·lbf}

3. INSTALL NO. 1 MULTI-MEDIA MODULE BRACKET

(a) w/o Mayday System:

(1) Install the No. 1 multi-media module bracket with the 2 screws. Torque: 3.0 N·m {31 kgf·cm, 27 in·lbf}

(b) w/ Mayday System:

(1) Install the No. 1 multi-media module bracket with the 3 screws. Torque: 3.0 N·m {31 kgf·cm, 27 in·lbf}

4. INSTALL TELEPHONE ECU WIRE (TO TRANSCEIVER) (w/ Mayday System)

(a) Attach the clamp to install the telephone ECU wire (to transceiver).

(b) Connect the 2 connectors.

5. INSTALL NO. 2 NAVIGATION WIRE

(a) w/ Mayday System:

(1) Attach the clamp to install the No. 2 navigation wire.

(2) Connect the connector.

(b) w/o Mayday System:

(1) Attach the clamp to install the No. 2 navigation wire.

(2) Connect the connector.

6. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY

(a) w/ Mayday System:

(1) Attach the clamp to install the No. 2 antenna cord sub-assembly.

(2) Connect the 4 connectors.

(b) w/o Mayday System:

(1) Attach the clamp to install the No. 2 antenna cord sub-assembly.

(2) Connect the connector.

7. INSTALL NAVIGATION ECU WITH BRACKET

(a) w/ Mayday System:

(1) Connect the 2 connectors.

(2) Place your hand at the position shown in the illustration, and then while bending the instrument panel safety pad assembly, attach the guide to temporarily install the navigation ECU with bracket.

	Place hand here
	Install in this Direction

(3) Attach the clamp and connect the 4 connectors.

	Bolt
	Connector

(4) Install the 2 bolts.

Torque:

12 N·m {122 kgf·cm, 9 ft·lbf}

(b) w/o Mayday System:

(1) Connect each connector.

	Place Hand Here
	Install in this Direction

(2) Place your hand at the position shown in the illustration, and then while bending the instrument panel safety pad assembly, attach the guide to temporarily install the navigation ECU with bracket.

(3) Attach the clamp and connect the 3 connectors.

	Bolt
	Connector

(4) Install the 2 bolts.

Torque:

12 N·m {122 kgf·cm, 9 ft·lbf}

8. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL

Click here

9. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

Click here

10. INSTALL CONSOLE BOX ASSEMBLY

Click here