| 
                           Last Modified: 05-08-2025 | 
                        6.11:8.1.0  | 
                        
                           Doc ID: RM100000001FAO1 | 
                      
                     
                        | 
                           Model Year Start: 2019 | 
                        
                           Model: RAV4 | 
                        
                           Prod Date Range: [11/2018 -                    
                                       ] | 
                      
                     
                        | 
                           Title: HEATING / AIR CONDITIONING: BLOWER UNIT: REMOVAL; 2019 - 2025 MY RAV4 RAV4 HV [11/2018 -        ] | 
                      
                   
                  REMOVAL
                   
                  CAUTION / NOTICE / HINT
                  HINT: 
                  Before removing the blower assembly, set the air conditioning to recirculation mode. 
                   
                  PROCEDURE
                   
                  1. REMOVE AIR CONDITIONING UNIT ASSEMBLY 
                  (a) for A25A-FXS: 
                  Click here
                        
                           
                               
                           
                        
                        
                           
                               
                           
                        
                        
                           
                               
                           
                        
                        
                           
                               
                           
                        
                        
                           
                               
                           
                        
                        
                           
                               
                           
                        
                        
                           
                               
                           
                        
                     
                   
                  (b) for A25A-FKS: 
                  Click here
                        
                           
                               
                           
                        
                        
                           
                               
                           
                        
                        
                           
                               
                           
                        
                        
                           
                               
                           
                        
                        
                           
                               
                           
                        
                     
                   
                   
                  2. REMOVE NO. 2 AIR DUCT (for TMC Made) 
                  
                  (b) Detach the claw to remove the No. 2 air duct. 
                  
                     NOTICE: 
                     
                        - 
Be careful not to deform or damage the lower heater case of the air conditioner unit assembly when removing the No. 2 air duct.
 
                        - 
If the fitting part of the No. 2 air duct has been cracked or deformed during removal, make sure to replace the air duct with a new one. Failure to do so may cause the No. 2 air duct to fall off or noise to occur.
 
                      
                   
                   
                  3. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY (for TMMC Made) 
                  HINT: 
                  Use the same procedure described as for the No. 2 air duct (for TMC Made). 
                   
                  4. REMOVE BLOWER ASSEMBLY 
                  
                     
                        
                           | 
                               (a) Disconnect the connector. 
                            | 
                           
                              
                            | 
                         
                     
                   
                  (b) Detach the clamp and guide. 
                  
                  (d) Detach the claw and guide and remove the blower assembly. 
                  
                |