| Last Modified: 05-08-2025 | 6.11:8.1.0 | Doc ID: RM100000001FATQ |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - ] |
| Title: AUDIO / VIDEO: REAR DOOR SPEAKER: REMOVAL; 2019 - 2025 MY RAV4 RAV4 HV [11/2018 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH
Click here
![2019 MY RAV4 RAV4 HV [11/2018 - 02/2019]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+](/t3Portal/stylegraphics/info.gif)
2. REMOVE DOOR ASSIST GRIP COVER LH
Click here
3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
Click here
4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
Click here
5. REMOVE REAR SPEAKER ASSEMBLY
NOTICE:
Do not touch the cone part of the speaker.
(a) Disconnect the connector.
|
*A |
w/o Woofer |
*B |
w/ Woofer |
|
Rivet |
|
Connector |
(b) Put a 5 mm (0.197 in.) drill bit into a drill.
(c) Wind tape around the drill bit approximately 4 mm (0.157 in.) from the tip of the drill as shown in the illustration.
NOTICE:
Tape the 5 mm (0.197 in.) drill bit to prevent the drill bit from going too deep.
Standard:
|
Area |
Specified Condition |
|---|---|
|
a |
4 mm (0.157 in.) |
(d) Lightly press the drill against the 3 rivets, drill off the flanges of the 3 rivets and remove the rear speaker assembly.
CAUTION:
Be careful of the drilled rivet as it may become hot.
NOTICE:
- Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.
- Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.
(e) Continue drilling and push out the remaining rivet fragments.
(f) Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.
|
|