Last Modified: 05-08-2025 6.11:8.1.0 Doc ID: RM100000001FERU
Model Year Start: 2019 Model: RAV4 Prod Date Range: [11/2018 -           ]
Title: STOP AND START: STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY: INSPECTION; 2019 - 2025 MY RAV4 [11/2018 -        ]

INSPECTION

PROCEDURE

1. INSPECT ECO RUN CANCEL SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

5 (ECU) - 2 (E)

Pushed

Below 1 Ω

Not pushed

10 kΩ or higher

If the result is not as specified, replace the eco run cancel switch assembly.

*a

Component without harness connected

(Eco Run Cancel Switch Assembly)

(b) Apply battery voltage between the terminals of the switch, and check the illumination condition of the eco run cancel switch assembly.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → 6 (ILL+)

Battery negative (-) → 1 (ILL-)

Illuminates

If the result is not as specified, replace the eco run cancel switch assembly.

*a

Component without harness connected

(Eco Run Cancel Switch Assembly)