Last Modified: 01-30-2024 |
6.11:8.1.0 |
Doc ID: RM100000001FHD0 |
Model Year Start: 2019 |
Model: RAV4 |
Prod Date Range: [11/2018 -
] |
Title: AXLE AND DIFFERENTIAL: REAR AXLE HUB: ON-VEHICLE INSPECTION; 2019 - 2024 MY RAV4 RAV4 HV [11/2018 - ] |
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
HINT:
-
Use the same procedure for the RH and LH sides.
-
The following procedure is for the LH side.
PROCEDURE
1. DISABLE BRAKE CONTROL (w/o Vacuum Brake Booster)
Click here
2. REMOVE REAR WHEEL
Click here
3. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
Click here
4. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH
-
for 2WD: Click here
-
for AWD: Click here
5. REMOVE REAR DISC
Click here
6. INSPECT REAR AXLE HUB BEARING LOOSENESS
(a) Using a dial indicator, check for looseness near the center of the rear axle hub.
Maximum looseness:
0.05 mm (0.00197 in.)
NOTICE:
-
Ensure that the dial indicator is set perpendicular to the measurement surface.
-
Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.
HINT:
If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.
|
|
7. INSPECT REAR AXLE HUB RUNOUT
(a) Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolts.
Maximum runout:
0.05 mm (0.00197 in.)
NOTICE:
-
Ensure that the dial indicator is set perpendicular to the measurement surface.
-
Make sure to install the tip of the dial indicator towards the outside of the rear axle hub bolts.
-
Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.
HINT:
If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.
|
|
8. INSTALL REAR DISC
Click here
9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
-
for 2WD: Click here
-
for AWD: Click here
10. CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
Click here
11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (w/o Vacuum Brake Booster)
(a) Connect the reservoir level switch connector.
(b) Connect the cable to the negative (-) auxiliary battery terminal.
Click here
(c) Perform the following procedure if air bleeding is not necessary:
(1) Turn the ignition switch on (READY).
(2) Depress the brake pedal and release it.
(3) Clear the DTCs.
Click here
12. INSTALL REAR WHEEL
Click here
|