| Last Modified: 05-08-2025 | 6.11:8.1.0 | Doc ID: RM100000001FHYF |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - 10/2022] |
| Title: PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: DATA LIST / ACTIVE TEST; 2019 - 2022 MY RAV4 RAV4 HV [11/2018 - 10/2022] | ||
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Rear Camera / Data List.
(e) Read the Data List according to the display on the Techstream.
Chassis > Rear Camera > Data List
|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Video Output Status |
Output condition of video signal |
OK or NG |
OK: Output condition of video signal is normal NG: Output condition of video signal is abnormal |
- |
|
HV/ENG Data Check |
Verification of the HV/ENG data |
OK or NG |
OK: Data verification normal NG: Data verification abnormal |
- |
|
Destination Data Check |
Verification of destination data |
OK or NG |
OK: Data verification normal NG: Data verification abnormal |
- |
|
RHD/LHD Signal Check |
Verification of RHD/LHD signal |
OK or NG |
OK: Data verification normal NG: Data verification abnormal |
- |
|
Circumference Monitoring System Type Check |
Verification of television camera assembly signal |
OK or NG |
OK: Television camera assembly normal NG: Television camera assembly abnormal |
- |
|
EEPROM Status (Initial read) |
Television camera assembly information |
OK or NG |
OK: Television camera assembly normal NG: Television camera assembly abnormal |
- |
|
CPU Communication Status |
Television camera assembly information |
OK or NG |
OK: Television camera assembly normal NG: Television camera assembly abnormal |
- |
|
Number of DTC |
Number of stored DTCs |
min.: 0, max.: 255 |
Number of DTCs will be displayed |
- |
|
Current Key Cycle |
Cumulative number of times the ignition switch was turned to ON |
Min.: 0, Max.: 65535 time |
Cumulative number of times the ignition switch was turned to ON will be displayed |
- |
|
Current Key Cycle Elapsed Time |
Time elapsed since the ignition switch was turned to ON |
Min.: 0, Max.: 53687091.1 s |
Time elapsed since the ignition switch was turned to ON will be displayed |
- |
|
|