| Last Modified: 02-14-2025 | 6.11:8.1.0 | Doc ID: RM100000001FJ06 |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - ] |
| Title: WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch; 2019 - 2025 MY RAV4 RAV4 HV [11/2018 - ] | ||
|
Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch |
DESCRIPTION
When the ignition switch is ON, the front power window regulator motor assembly RH is operated by the power window regulator switch assembly. The front power window regulator motor assembly RH has motor, regulator and ECU functions.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
Click here
![2019 - 2023 MY RAV4 RAV4 HV [11/2018 - 10/2023]; WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING](/t3Portal/stylegraphics/info.gif)
-
If the power window regulator motor assembly has been replaced with a new one, initialize the power window control system.
Click here
- Check that the window lock switch is off before performing the following procedure.
- Inspect the fuse for circuits related to this system before performing the following procedure.
PROCEDURE
|
1. |
READ VALUE USING TECHSTREAM (P-DOOR MOTOR) |
(a) Using the Techstream, read the data for the condition when the power window regulator switch assembly was operated.
Click here
Body Electrical > P-Door Motor > Data List
|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
P Door P/W Up SW |
Front passenger door power window manual up switch signal |
OFF or ON |
OFF: Front passenger door power window manual up switch not being operated ON: Front passenger door power window manual up switch being operated |
- |
|
P Door P/W Down SW |
Front passenger door power window manual down switch signal |
OFF or ON |
OFF: Front passenger door power window manual down switch not being operated ON: Front passenger door power window manual down switch being operated |
- |
Body Electrical > P-Door Motor > Data List
|
Tester Display |
|---|
|
P Door P/W Up SW |
|
P Door P/W Down SW |
OK:
On the Techstream screen, ON or OFF is displayed accordingly.
| OK |
|
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
|
|
|
2. |
INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY |
(a) Remove the power window regulator switch assembly.
Click here
(b) Inspect the power window regulator switch assembly.
Click here
| NG |
|
|
|
3. |
CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY - FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH) |
(a) Disconnect the I3 power window regulator switch assembly connector.
(b) Disconnect the I7 front power window regulator motor assembly RH connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
I3-5 (UP) - I7-10 (UP) |
Always |
Below 1 Ω |
|
I3-4 (DOWN) - I7-7 (DOWN) |
Always |
Below 1 Ω |
|
I3-8 (AUTO) - I7-4 (AUTO) |
Always |
Below 1 Ω |
|
I3-5 (UP) or I7-10 (UP) - Body ground |
Always |
10 kΩ or higher |
|
I3-4 (DOWN) or I7-7 (DOWN) - Body ground |
Always |
10 kΩ or higher |
|
I3-8 (AUTO) or I7-4 (AUTO) - Body ground |
Always |
10 kΩ or higher |
| OK |
|
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|