Last Modified: 02-14-2025 |
6.11:8.1.0 |
Doc ID: RM100000001FJ07 |
Model Year Start: 2019 |
Model: RAV4 |
Prod Date Range: [11/2018 -
] |
Title: WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: Rear Power Window LH does not Operate with Rear Power Window Switch LH; 2019 - 2025 MY RAV4 RAV4 HV [11/2018 - ] |
Rear Power Window LH does not Operate with Rear Power Window Switch LH
|
DESCRIPTION
When the ignition switch is ON, the rear power window regulator motor assembly LH is operated by the rear power window regulator switch assembly LH. The rear power window regulator motor assembly LH has motor, regulator and ECU functions.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
PROCEDURE
1.
|
READ VALUE USING TECHSTREAM (RL-DOOR MOTOR)
|
(a) Using the Techstream, read the data for the condition when the rear power window regulator switch assembly LH was operated.
Click here
Body Electrical > RL-Door Motor > Data List
Tester Display
|
Measurement Item
|
Range
|
Normal Condition
|
Diagnostic Note
|
RL Door P/W Up SW
|
Rear LH door power window manual up switch signal
|
OFF or ON
|
OFF: Rear LH door power window manual up switch not being operated
ON: Rear LH door power window manual up switch being operated
|
-
|
RL Door P/W Down SW
|
Rear LH door power window manual down switch signal
|
OFF or ON
|
OFF: Rear LH door power window manual down switch not being operated
ON: Rear LH door power window manual down switch being operated
|
-
|
Body Electrical > RL-Door Motor > Data List
Tester Display
|
RL Door P/W Up SW
|
RL Door P/W Down SW
|
OK:
On the Techstream screen, ON or OFF is displayed accordingly.
NG
|
|
|
2.
|
INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH
|
(a) Remove the rear power window regulator switch assembly LH.
Click here
(b) Inspect the rear power window regulator switch assembly LH.
Click here
OK
|
|
|
3.
|
CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH - REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH)
|
(a) Disconnect the L2 rear power window regulator switch assembly LH connector.
(b) Disconnect the L5 rear power window regulator motor assembly LH connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
L2-5 (UP) - L5-10 (UP)
|
Always
|
Below 1 Ω
|
L2-4 (DOWN) - L5-7 (DOWN)
|
Always
|
Below 1 Ω
|
L2-5 (UP) or L5-10 (UP) - Body ground
|
Always
|
10 kΩ or higher
|
L2-4 (DOWN) or L5-7 (DOWN) - Body ground
|
Always
|
10 kΩ or higher
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|