| Last Modified: 05-08-2025 | 6.11:8.1.0 | Doc ID: RM100000001FJ26 |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - ] |
| Title: WIPER / WASHER: WIPER AND WASHER SYSTEM: Washer Fluid Level Warning Switch Circuit; 2019 - 2025 MY RAV4 RAV4 HV [11/2018 - ] | ||
|
Washer Fluid Level Warning Switch Circuit |
DESCRIPTION
When the washer fluid level is lower than a certain level, a warning message is displayed on the combination meter assembly.
WIRING DIAGRAM
PROCEDURE
|
1. |
READ VALUE USING TECHSTREAM (WASHER LEVEL WARNING SWITCH) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Combination Meter / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Combination Meter > Data List
|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Washer Level Warning Switch |
Windshield washer JAR assembly (Level warning switch) state |
OFF or ON |
ON: Washer fluid level low OFF: Washer fluid level not low |
- |
Body Electrical > Combination Meter > Data List
|
Tester Display |
|---|
|
Washer Level Warning Switch |
OK:
The Techstream display changes correctly in response to the washer fluid level.
| OK |
|
REPLACE COMBINATION METER ASSEMBLY
|
|
|
2. |
CHECK LEVEL WARNING SWITCH ASSEMBLY |
(a) Disconnect the A3 level warning switch assembly connector.
(b) Check the level warning switch assembly.
Click here
![2019 - 2025 MY RAV4 RAV4 HV [11/2018 - ]; WIPER / WASHER: WASHER LEVEL WARNING SWITCH: ON-VEHICLE INSPECTION](/t3Portal/stylegraphics/info.gif)
| NG |
|
REPLACE LEVEL WARNING SWITCH ASSEMBLY
|
|
|
3. |
CHECK HARNESS AND CONNECTOR (LEVEL WARNING SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND) |
(a) Disconnect the A3 level warning switch assembly connector.
(b) Disconnect the G19 combination meter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
A3-1 (S) - G19-14 (WLVL) |
Always |
Below 1 Ω |
|
A3-2 (E) - Body ground |
Always |
Below 1 Ω |
|
A3-1 (S) or G19-14 (WLVL) - Body ground |
Always |
10 kΩ or higher |
| OK |
|
REPLACE COMBINATION METER ASSEMBLY
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|