| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001FMOG |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - 08/2020] |
| Title: A25A-FKS (ENGINE CONTROL): SFI SYSTEM (w/o Canister Pump Module): DTC CHECK / CLEAR; 2019 - 2020 MY RAV4 [11/2018 - 08/2020] | ||
DTC CHECK / CLEAR
NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and Freeze Frame Data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and Freeze Frame Data.
HINT:
- DTCs which are stored in the ECM can be displayed on the Techstream. The Techstream can display the confirmed and pending DTCs.
- Some DTCs are not stored if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine / Trouble Codes.
Powertrain > Engine > Trouble Codes
(e) Check the DTC(s) and Freeze Frame Data, and then write them down.
|
Techstream Display |
Description |
|---|---|
|
Test Failed |
Shows the malfunction judgment results during the current trip. |
|
Pending |
Shows the malfunction judgment results up to now. (Indicates the possibility of a malfunction when no DTC is confirmed.) |
|
Confirmed |
Shows the DTCs confirmed up to now. (The number of current trips differs for each DTC.) |
(f) Check the details of the DTC(s).
Click here
![2019 - 2020 MY RAV4 [11/2018 - 08/2020]; A25A-FKS (ENGINE CONTROL): SFI SYSTEM (w/o Canister Pump Module): DIAGNOSTIC TROUBLE CODE CHART](/t3Portal/stylegraphics/info.gif)
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine / Trouble Codes.
(e) Clear the DTCs.
Powertrain > Engine > Clear DTCs
CLEAR DTC (without using Techstream)
(a) Perform either of the following operations:
NOTICE:
After turning ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
(1) Disconnect the cable from the negative (-) battery terminal for more than 1 minute.
(2) Remove the EFI-MAIN NO. 4 fuse from the No. 1 engine room relay block and junction block assembly located inside the engine compartment for more than 1 minute.
|
|