Last Modified: 05-08-2025 6.11:8.1.0 Doc ID: RM100000001FNEW
Model Year Start: 2019 Model: RAV4 Prod Date Range: [11/2018 -           ]
Title: UB80E (AUTOMATIC TRANSMISSION / TRANSAXLE): COMBINATION SWITCH: INSPECTION; 2019 - 2025 MY RAV4 [11/2018 -        ]

INSPECTION

PROCEDURE

1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (COMBINATION SWITCH)

(a) Inspect the NORMAL mode switch:

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

8 (B) - 13 (GND)

NORMAL mode switch being pushed and held

Below 1 Ω

NORMAL mode switch not pushed

10 kΩ or higher

If the result is not as specified, replace the integration control and panel assembly (combination switch).

*a

Component without harness connected

(Integration Control and Panel Assembly (Combination Switch))

(b) Inspect the SPORT mode switch:

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

9 (P) - 13 (GND)

SPORT mode switch being pushed and held

Below 1 Ω

SPORT mode switch not pushed

10 kΩ or higher

If the result is not as specified, replace the integration control and panel assembly (combination switch).

*a

Component without harness connected

(Integration Control and Panel Assembly (Combination Switch))

(c) Inspect the ECO mode switch:

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

7 (ECU) - 13 (GND)

ECO mode switch being pushed and held

Below 1 Ω

ECO mode switch not pushed

10 kΩ or higher

If the result is not as specified, replace the integration control and panel assembly (combination switch).

*a

Component without harness connected

(Integration Control and Panel Assembly (Combination Switch))

(d) Inspect the illumination:

(1) Apply battery voltage to the combination switch and check that the switch illuminates.

OK:

Condition

Specified Condition

Battery positive (+) → Terminal 12 (ILL+)

Battery negative (-) → Terminal 1 (ILL-)

Illuminates

If the result is not as specified, replace the integration control and panel assembly (combination switch).

*a

Component without harness connected

(Integration Control and Panel Assembly (Combination Switch))