Last Modified: 01-30-2024 |
6.11:8.1.0 |
Doc ID: RM100000001FNIC |
Model Year Start: 2019 |
Model: RAV4 |
Prod Date Range: [11/2018 -
] |
Title: NETWORKING: LIN COMMUNICATION SYSTEM: B2789; No Response from ID BOX; 2019 - 2024 MY RAV4 RAV4 HV [11/2018 - ] |
DTC
|
B2789
|
No Response from ID BOX
|
DESCRIPTION
This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) stops for 10 seconds or more.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
B2789
|
No Response from ID BOX
|
No communication between certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) for 10 seconds or more.
|
-
ID code box (immobiliser code ECU)
-
Certification ECU (smart key ECU assembly)
-
Harness or connector
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
HINT:
When the communication between the ID code box (immobiliser code ECU) and certification ECU (smart key ECU assembly) stops, DTC B2785 is also stored.
PROCEDURE
(a) Clear the DTCs.
Click here
Body Electrical > Smart Key > Clear DTCs
(b) Check for DTCs.
Click here
Body Electrical > Smart Key > Trouble Codes
Result
|
Proceed to
|
DTC B2789 is output
|
A
|
DTC B2789 is not output
|
B
|
A
|
|
|
2.
|
CHECK HARNESS AND CONNECTOR (ID CODE BOX [IMMOBILISER CODE ECU] - AUXILIARY BATTERY AND BODY GROUND)
|
(a) Disconnect the ID code box (immobiliser code ECU) connector.
|
|
*a
|
Front view of wire harness connector
(to ID Code Box [Immobiliser Code ECU])
|
|
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
G57-5 (GND) - Body ground
|
Always
|
Below 1 Ω
|
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
|
Switch Condition
|
Specified Condition
|
G57-1 (+B) - Body ground
|
Ignition switch off
|
11 to 14 V
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
OK
|
|
|
3.
|
CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - ID CODE BOX [IMMOBILISER CODE ECU])
|
(a) Disconnect the G54 certification ECU (smart key ECU assembly) connector.
(b) Disconnect the G57 ID code box (immobiliser code ECU) connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
G54-13 (LIN) - G57-2 (LIN1)
|
Always
|
Below 1 Ω
|
G54-13 (LIN) - Body ground
|
Always
|
10 kΩ or higher
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|