Last Modified: 01-30-2024 |
6.11:8.1.0 |
Doc ID: RM100000001FP5A |
Model Year Start: 2019 |
Model: RAV4 |
Prod Date Range: [11/2018 - 10/2022] |
Title: METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: Entire Combination Meter does not Operate; 2019 - 2022 MY RAV4 RAV4 HV [11/2018 - 10/2022] |
Entire Combination Meter does not Operate
|
DESCRIPTION
This circuit is the power source circuit for the combination meter assembly. This circuit provides two types of power sources; one is a constant power source, and the other is an IG power source.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
-
Inspect the fuses of circuits related to this system before performing the following procedure.
PROCEDURE
1.
|
CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY AND BODY GROUND)
|
*a
|
Front view of wire harness connector
(to Combination Meter Assembly)
|
(a) Disconnect the combination meter assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
G18-19 (EP) - Body ground
|
Always
|
Below 1 Ω
|
G18-23 (ES) - Body ground
|
Always
|
Below 1 Ω
|
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
|
Switch Condition
|
Specified Condition
|
G18-38 (IG+) - Body ground
|
Ignition switch off
|
Below 1 V
|
Ignition switch ON
|
10.5 to 16 V*1
11 to 14 V*2
|
G18-22 (B) - Body ground
|
Ignition switch off
|
11 to 14 V
|
Result
|
Proceed to
|
OK
|
A
|
NG (IG+ terminal) (w/ Stop and Start System)
|
B
|
NG (IG+ terminal) (w/o Stop and Start System)
|
C
|
NG (Other terminal)
|
C |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|