| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001FPIJ |
| Model Year Start: 2019 | Model: RAV4 HV | Prod Date Range: [11/2018 - 10/2022] |
| Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM (for HV Model): C1682; Front Camera Current Malfunction; 2019 - 2022 MY RAV4 HV [11/2018 - 10/2022] | ||
|
DTC |
C1682 |
Front Camera Current Malfunction |
DESCRIPTION
This DTC is stored if the parking assist ECU judges as a result of its self check that there is a problem with the current supplied from the front television camera assembly connected to the parking assist ECU.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1682 |
Front Camera Current Malfunction |
Open or short in the front television camera signal circuit |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" mark is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click here
![2019 - 2022 MY RAV4 HV [11/2018 - 10/2022]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM (for HV Model): INITIALIZATION](/t3Portal/stylegraphics/info.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as panoramic view monitor system may be needed.
Click here
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - FRONT TELEVISION CAMERA ASSEMBLY) |
(a) Disconnect the N24 parking assist ECU connector.
(b) Disconnect the B12 front television camera assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
N24-15 (BCB+) - B12-6 (BCB+) |
Always |
Below 1 Ω |
|
N24-37 (BGND) - B12-5 (BGND) |
Always |
Below 1 Ω |
|
N24-15 (BCB+) or B12-6 (BCB+) - Body ground |
Always |
10 kΩ or higher |
|
N24-37 (BGND) or B12-5 (BGND) - Body ground |
Always |
10 kΩ or higher |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
2. |
CHECK PARKING ASSIST ECU (BCB+, BGND) |
|
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
N24-15 (BCB+) - N24-37 (BGND) |
Power switch on (IG) |
5.5 to 7.05 V |
|
N24-15 (BCB+) - N24-37 (BGND) |
Power switch off |
Below 1 V |
| OK |
|
| NG |
|
|
|