| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000001FXRO |
| Model Year Start: 2019 | Model: RAV4 | Prod Date Range: [11/2018 - 10/2019] |
| Title: CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: B15C6; Ignition Switch Signal Malfunction; 2019 MY RAV4 RAV4 HV [11/2018 - 10/2019] | ||
|
DTC |
B15C6 |
Ignition Switch Signal Malfunction |
DESCRIPTION
If vehicle movement (10 km/h (6 mph) or more for 10 seconds) is detected based on the location data sent from the radio and display receiver assembly even when the DCM (Telephone Transceiver Assembly) detects that the ignition switch is off, this DTC will be stored.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
B15C6 |
Ignition Switch Signal Malfunction |
IG signal error |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
|
1. |
CHECK DTC OUTPUT |
(a) Clear the DTCs.
Click here
![2019 MY RAV4 RAV4 HV [11/2018 - 10/2019]; CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: DTC CHECK / CLEAR](/t3Portal/stylegraphics/info.gif)
Body Electrical > Telematics > Clear DTCs
(b) Recheck for DTCs and check if the same DTC is output again.
Click here
Body Electrical > Telematics > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
B15C6 is not output. |
A |
|
B15C6 is output. |
B |
| A |
|
|
|
2. |
CHECK HARNESS AND CONNECTOR (DCM (TELEPHONE TRANSCEIVER ASSEMBLY) - BATTERY AND BODY GROUND) |
(a) Disconnect the G9 DCM (Telephone Transceiver Assembly) connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
G9-4 (E) - Body ground |
Always |
Below 1 Ω |
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
*1: w/ Stop and Start System
*2: w/o Stop and Start System |
||
|
G9-7 (IG2) - Body ground |
Ignition switch ON |
10.5 to 16 V*1 11 to 14 V*2 |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
3. |
REPLACE DCM (TELEPHONE TRANSCEIVER ASSEMBLY) |
(a) Replace the DCM (Telephone Transceiver Assembly).
Click here
NOTICE:
- The ignition switch must be off.
- Do not exchange the DCM (Telephone Transceiver Assembly) with one from another vehicle.
| NEXT |
|
|
|