Last Modified: 01-30-2024 6.11:8.1.0 Doc ID: RM100000001G0ON
Model Year Start: 2019 Model: RAV4 Prod Date Range: [11/2018 -           ]
Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR (for AWD): REMOVAL; 2019 - 2024 MY RAV4 RAV4 HV [11/2018 -        ]

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE REAR WHEEL

Click here 2019 - 2024 MY RAV4 RAV4 HV [11/2018 -        ]; MAINTENANCE: TIRE AND WHEEL: REMOVAL

2. REMOVE REAR SKID CONTROL SENSOR LH

(a) Using a screwdriver with its tip wrapped with protective tape, Disconnect the rear skid control sensor connector from the rear skid control sensor LH.

NOTICE:

  • Remove any dirt or foreign matter on and around the rear skid control sensor connector before performing this step.
  • Be careful not to damage the rear skid control sensor or connector cover.

*a

Protective Tape

(b) Remove the bolt and rear skid control sensor LH from the rear axle carrier sub-assembly.

NOTICE:

  • Keep the tip of the rear skid control sensor LH and installation hole free of foreign matter.
  • Do not rotate or apply excessive force to the rear skid control sensor LH when removing it from the rear axle carrier sub-assembly. Rotating or applying excessive force may result in damage to the rear skid control sensor.