THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function, Gasoline Model): DTC CHECK / CLEAR; 2019 - 2021 MY RAV4 [11/2018

NOTICE:

When DTC is output, Be sure to confirm and record.
DTCs may have been stored due to problems unrelated to the steering lock function. Be sure to confirm and record any DTCs output for other systems.
When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
The steering lock ECU (steering lock actuator with ECU assembly) does not store history DTCs. If any DTCs are output, confirm and record them as soon as possible. Do not turn the engine switch off or clear the DTCs until the DTCs are confirmed and recorded.

Powertrain > Engine > Trouble Codes

(e) Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.

Body Electrical > Power Source Control > Trouble Codes

Body Electrical > Smart Key > Trouble Codes

(g) Enter the following menus: Body Electrical / Starting Control / Trouble Codes.

Body Electrical > Starting Control > Trouble Codes

HINT:

The steering lock function DTCs are output from the steering lock ECU (steering lock actuator with ECU assembly) via the certification ECU (smart key ECU assembly).
When any DTC is not output and security indicator light does not blink, problems may be caused by the following:
- Open in TC circuit between DLC3 and related ECU
- Malfunction of related ECU

Powertrain > Engine > Clear DTCs

(e) Enter the following menus: Body Electrical / Power Source Control / Clear DTCs.

DTC CHECK / CLEAR