A25A-FXS (ENGINE CONTROL): KNOCK SENSOR: INSTALLATION; 2019 - 2020 MY RAV4 HV [02/2019

Last Modified: 01-30-2024	6.11:8.1.0	Doc ID: RM100000001H9BF
Model Year Start: 2019	Model: RAV4 HV	Prod Date Range: [02/2019 - 08/2020]
Title: A25A-FXS (ENGINE CONTROL): KNOCK SENSOR: INSTALLATION; 2019 - 2020 MY RAV4 HV [02/2019 - 08/2020]

INSTALLATION

CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.

w/ Canister Pump Module:
Click here
w/o Canister Pump Module:
Click here

PROCEDURE

1. INSTALL KNOCK CONTROL SENSOR

HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.

w/ Canister Pump Module:
Click here
w/o Canister Pump Module:
Click here

(a) Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

Torque:

20 N·m {204 kgf·cm, 15 ft·lbf}

NOTICE:

If the knock control sensor has been struck or dropped, replace it.
Make sure that the knock control sensor is in the correct position.

*a	Top
*b	Right of Vehicle
*c	15°
*d	5°

(b) Connect the knock control sensor connector.

2. INSTALL INTAKE MANIFOLD

Click here