INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click here

PROCEDURE

1. INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click here

(a) for Sensor 2:

(1) Using SST, install the air fuel ratio sensor to the front exhaust pipe assembly. SST: 09224-00012 Torque: Specified tightening torque : 44 N·m {449 kgf·cm, 32 ft·lbf} NOTICE: If the air fuel ratio sensor has been struck or dropped, replace it. HINT: Calculate the torque wrench reading when changing the fulcrum length of the torque wrench. Click here When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)

*a Torque Wrench Fulcrum Length

(2) Connect the air fuel ratio sensor connector.

*a Tie Band *b Wire Harness Clamp

(3) Attach the 2 wire harness clamps so that the tie band is positioned as shown in the illustration.

(b) for Sensor 1:

(1) Using SST, install the air fuel ratio sensor to the exhaust manifold. SST: 09224-00012 Torque: Specified tightening torque : 44 N·m {449 kgf·cm, 32 ft·lbf} NOTICE: If the air fuel ratio sensor has been struck or dropped, replace it. HINT: Calculate the torque wrench reading when changing the fulcrum length of the torque wrench. Click here When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)

*a Torque Wrench Fulcrum Length

(2) Connect the air fuel ratio sensor connector.

*a Tie Band *b Wire Harness Clamp

(3) Attach the 3 wire harness clamps so that the tie band is positioned as shown in the illustration.

2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Click here

3. INSPECT FOR EXHAUST GAS LEAK

Click here