NOTICE:

• If the auxiliary battery is connected, the parking brake will operate when the electric parking brake switch assembly is pulled to the lock side even if the ignition switch is off. Do not operate the electric parking brake switch assembly with the auxiliary battery connected unless specified in the repair manual.
• To prevent the electric parking brake system from operating when the shift lever is moved, make sure that the shift-linked function is disabled.
• The electric parking brake may still operate for 20 seconds* after the ignition switch is turned off. (w/ Vacuum Brake Booster)
  • *: The electric parking brake may still operate up to 60 minutes depending on the state of the vehicle after the ignition switch is turned off, so be sure to perform the work procedures with the vehicle on a level surface.
• When disconnecting a connector or removing a fuse or relay, make sure that the ignition switch has been off, the brake pedal has not been depressed, and the driver door has been closed for 4 minutes or more*. (w/o Vacuum Brake Booster)
  • *: The electric parking brake may still operate up to 60 minutes depending on the state of the vehicle after the ignition switch is turned off, so be sure to perform the work procedures with the vehicle on a level surface.
• If any part is removed and installed, check for DTCs to make sure that the normal system code is output after all parts are installed.
  • w/ Vacuum Brake Booster

    Click here

  • w/o Vacuum Brake Booster

    Click here

• Replacing a part with a part which does not meet the same specifications may affect the performance of the brake system or lead to a hazardous situation. When replacing a part, always use a part with the same part number or equivalent.
• When servicing the brake system, keep the parts and areas around the parts clean.
• If the vehicle is equipped with a mobile communication system, make sure to read the related precautions in Introduction.

  Click here

• When tilting the vehicle to perform work after parking the vehicle on a level surface, the braking force of the parking brake may not be sufficient. Make sure to pull the electric parking brake switch assembly to the lock side 2 times (2 lock operations).
  • The electric parking brake system determines the amount of force used to operate the parking brake according to the tilt angle detected by the deceleration sensor.
  • When the parking brake indicator (red) is illuminated after the electric parking brake switch assembly has been pulled to the lock side, the maximum amount of braking force is applied if the electric parking brake switch assembly is pulled to the lock side one more time.