- DTCs are stored
- Slight vibration at a vehicle speed of 5 km/h (3 mph) or less
- Shock or vibration during acceleration
| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM1000000026BTY |
| Model Year Start: 2023 | Model: RAV4 HV | Prod Date Range: [10/2022 - ] |
| Title: A25A-FXS (ENGINE CONTROL): ENGINE COOLANT TEMPERATURE SENSOR: REMOVAL; 2023 - 2024 MY RAV4 HV [10/2022 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Inverter with converter assembly |
Resolver learning |
|
for AWD with NICKEL METAL HYDRIDE BATTERY:
for LITHIUM-ION BATTERY:
|
|
ECM |
Perform Vehicle Identification Number (VIN) registration |
DTC P063051 is output |
|
|
Grille shutter switch specification infomation |
Vehicle control history (RoB) [X260E] is stored |
|
|
|
Engine coolant temperature sensor |
Inspection after repair |
|
|
PROCEDURE
1. DRAIN ENGINE COOLANT
Click here
![2022 - 2024 MY RAV4 HV [12/2021 - ]; MAINTENANCE: A25A-FXS COOLANT (for Engine): REPLACEMENT](/t3Portal/stylegraphics/info.gif)
2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Grille Shutter)
Click here
3. REMOVE INLET AIR CLEANER ASSEMBLY (w/ Grille Shutter)
Click here
4. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE (w/ Grille Shutter)
Click here
5. REMOVE NO. 2 ENGINE COOLANT TEMPERATURE SENSOR (w/ Grille Shutter)
|
(a) Disconnect the No. 2 engine coolant temperature sensor connector. |
|
|
(b) Remove the clip and No. 2 engine coolant temperature sensor from the water outlet. NOTICE: If the No. 2 engine coolant temperature sensor has been struck or dropped, replace it. |
|
6. REMOVE INVERTER WITH CONVERTER ASSEMBLY
Click here
7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR
|
(a) Disconnect the engine coolant temperature sensor connector. |
|
|
(b) Remove the clip and engine coolant temperature sensor from the water outlet. NOTICE: If the engine coolant temperature sensor has been struck or dropped, replace it. |
|
|
|