| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM1000000026SV4 |
| Model Year Start: 2023 | Model: RAV4 HV | Prod Date Range: [10/2022 - ] |
| Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM (for HV Model): C162287; Rear Camera Image Signal Missing Message; 2023 - 2024 MY RAV4 HV [10/2022 - ] | ||
|
DTC |
C162287 |
Rear Camera Image Signal Missing Message |
DESCRIPTION
This DTC is stored if the parking assist ECU judges as a result of its self check that the signals or signal lines between the parking assist ECU and the rear television camera assembly are not normal.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
Priority |
|---|---|---|---|---|---|
|
C162287 |
Rear Camera Image Signal Missing Message |
Open or short in the rear television camera signal circuit |
|
Circumference Monitoring Camera Control Module |
A |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
![2023 - 2024 MY RAV4 HV [10/2022 - ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM (for HV Model): CALIBRATION](/t3Portal/stylegraphics/info.gif)
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR TELEVISION CAMERA ASSEMBLY) |
Pre-procedure1
(a) Disconnect the N80 parking assist ECU connector.
(b) Disconnect the R31 rear television camera assembly connector.
Procedure1
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
N80-1 (CB+) - R31-2 (CB+) |
Always |
Below 1 Ω |
|
N80-3 (CV+) - R31-4 (CV+) |
Always |
Below 1 Ω |
|
N80-4 (CV-) - R31-3 (CV-) |
Always |
Below 1 Ω |
|
N80-2 (CGND) - R31-1 (CGND) |
Always |
Below 1 Ω |
|
N80-5 (SGND) - R31-5 (SGND) |
Always |
Below 1 Ω |
|
N80-1 (CB+) or R31-2 (CB+) - Body ground |
Always |
10 kΩ or higher |
|
N80-3 (CV+) or R31-4 (CV+) - Body ground |
Always |
10 kΩ or higher |
|
N80-4 (CV-) or R31-3 (CV-) - Body ground |
Always |
10 kΩ or higher |
|
N80-2 (CGND) or R31-1 (CGND) - Body ground |
Always |
10 kΩ or higher |
|
N80-5 (SGND) or R31-5 (SGND) - Body ground |
Always |
10 kΩ or higher |
Post-procedure1
(d) None
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
2. |
CHECK PARKING ASSIST ECU (CV-, CGND) |
Pre-procedure1
|
(a) Disconnect the N80 parking assist ECU connector. |
|
Procedure1
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
2 (CGND) - Body ground |
Always |
Below 1 Ω |
|
4 (CV-) - Body ground |
Always |
10 kΩ or higher |
Post-procedure1
(c) None
| NG |
|
|
|
3. |
CHECK PARKING ASSIST ECU (CB+, CGND) |
Pre-procedure1
(a) Disconnect the R31 rear television camera assembly.
Procedure1
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
R31-1 (CGND) - Body ground |
Always |
Below 1 Ω |
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
R31-2 (CB+) - R31-1 (CGND) |
Ignition switch ON |
7.5 to 8.5 V |
|
R31-2 (CB+) - R31-1 (CGND) |
Ignition switch off |
Below 1 V |
Post-procedure1
(d) None
| OK |
|
| NG |
|
|
|