- Poor idle, etc.
- Engine start function, etc.
| Last Modified: 05-08-2025 | 6.11:8.1.0 | Doc ID: RM1000000026THJ |
| Model Year Start: 2023 | Model: RAV4 | Prod Date Range: [10/2022 - ] |
| Title: A25A-FKS (ENGINE CONTROL): ACTIVE CONTROL ENGINE MOUNT (for Rear Side): REMOVAL; 2023 - 2025 MY RAV4 [10/2022 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear engine mounting insulator removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Exhaust system parts |
Inspection After Repair |
|
|
|
Suspension, tires, etc. |
Television camera assembly optical axis (Back camera position setting) |
Parking assist monitor system |
|
|
Parking assist ECU initialization |
Panoramic view monitor system (for Gasoline model) |
|
|
|
Front bumper assembly (Including removal and installation) |
Front television camera view adjustment |
Panoramic view monitor system (for Gasoline model) |
|
NOTICE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.
Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
|
System Name |
See Procedure |
|---|---|
|
Vehicle enrolled in Toyota Audio Multimedia system or safety connect system |
6 minutes |
|
Vehicle not enrolled in Toyota Audio Multimedia system and safety connect system |
1 minute |
PROCEDURE
1. REMOVE FRONT FRAME ASSEMBLY
Click here
![2023 MY RAV4 [10/2022 - 10/2023]; A25A-FKS (ENGINE MECHANICAL): ENGINE ASSEMBLY: REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE REAR ENGINE MOUNTING INSULATOR
|
(a) Remove the bolt and rear engine mounting insulator from the rear engine mounting bracket. |
|
|
(b) Remove the bolt and wire harness clamp bracket from the rear engine mounting insulator. |
|
|
(c) Detach the clamp and remove the vacuum hose from the rear engine mounting insulator. |
|
|
|