| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000002FQ24 |
| Model Year Start: 2024 | Model: RAV4 | Prod Date Range: [10/2023 - ] |
| Title: DOOR / HATCH: POWER BACK DOOR SYSTEM: B22049E; Kick Sensor Stuck ON; 2024 MY RAV4 RAV4 HV [10/2023 - ] | ||
|
DTC |
B22049E |
Kick Sensor Stuck ON |
DESCRIPTION
B22049E is output when the multiplex network door ECU detects that the kick door control sensor is stuck on.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
B22049E |
Kick Sensor Stuck ON |
One of the following conditions is met for approximately 60 seconds or more:
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
- Before troubleshooting, make sure that the kick door control sensor is not damaged.
-
Before troubleshooting, be sure to read Precautions for Hands Free Power Back Door.
Click here
![2024 MY RAV4 RAV4 HV [10/2023 - ]; DOOR / HATCH: POWER BACK DOOR SYSTEM: PRECAUTION](/t3Portal/stylegraphics/info.gif)
-
If the multiplex network door ECU has been replaced, or if any of the connectors has been disconnected, initialize the power back door system.
Click here
- Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
|
1. |
CLEAR DTC |
(a) Clear the DTCs.
Body Electrical > Back Door > Clear DTCs
|
|
2. |
REPRODUCE DTC |
(a) Turn the ignition switch to ON and wait for at least 60 seconds.
|
|
3. |
CHECK FOR DTC |
(a) Check for DTCs.
Body Electrical > Back Door > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
B22049E is not output |
A |
|
B22049E is output |
B |
| A |
|
|
|
4. |
CLEAR DTC |
(a) Disconnect the Q7 kick door control sensor connector.
(b) Clear the DTCs.
Body Electrical > Back Door > Clear DTCs
|
|
5. |
REPRODUCE DTC |
(a) Turn the ignition switch to ON and wait for at least 60 seconds.
|
|
6. |
CHECK FOR DTC |
(a) Check for DTCs.
Body Electrical > Back Door > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
B22049E is not output |
A |
|
B22049E is output |
B |
| A |
|
|
|
7. |
CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK DOOR ECU - KICK DOOR CONTROL SENSOR) |
(a) Disconnect the R26 multiplex network door ECU connector.
(b) Disconnect the Q7 kick door control sensor assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
R26-12 (KSIN) or Q7-3 (KSOT) - Body ground |
Always |
10 kΩ or higher |
| OK |
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|